Shift Indicator Light Not Working. I verified power at fuses 5, 9, and 10. When the vehicle was first turned on, the p led would illuminate, if i moved to r, it was also illuminated but as soon as i selected d, the centre console gear shift lever led would come on then immediately go out and no matter what gear i selected, i never saw the led illuminate until i turned off vehicle, car electronics shut down and i later started vehicle and p.
Shift indicator from www.hondagrom.net
Is it the nsbu switch or ignition? The engine module computer needs to be scanned. I removed and verified that the center console shift indicator bulb is good, and that there is no power to the bulb socket when the lights are switched on.
Determine If The Reading Is Between 12 And 25.
Perform the same procedures on this plug wire. One of the problems with the shift indicator not working and/or no start. Start by removing the nut on it with a 15mm then remove the shift linkage with the arm.
It Turns Out The Red Circled Connector Seems To Just Put Power And Run The Interior Back Lit Led's On The Display.
10 was blown, but replacing it with a new fuse did not change anything. I started my truck this afternoon and my shift indicator wouldnt light up but my mileage and information center was fine so i turned off my truck and back on but it still wouldnt light up. There are sure parts that wear out over the long haul and should be fixed by experts.
When The Vehicle Was First Turned On, The P Led Would Illuminate, If I Moved To R, It Was Also Illuminated But As Soon As I Selected D, The Centre Console Gear Shift Lever Led Would Come On Then Immediately Go Out And No Matter What Gear I Selected, I Never Saw The Led Illuminate Until I Turned Off Vehicle, Car Electronics Shut Down And I Later Started Vehicle And P.
Check engine light comes on the check engine light comes on for a variety of reasons and one of them is the shift. Move the shift lever to neutral and position the shift indicator bezel aside. Ford truck gear shift indicator display not working!!!!
On That Diagram They Show The Power Wire As Blue W/Red Stripe (Tag 19) That Leads To A Molded Plug (Wire Tag 490 Also Blue W/Red).
No steering wheel control lights, no center console shift indicator light. 3 try each gear position to determine how much misalignment is in the indicator. If you suspect your shift indicator is going bad, watch for the following symptoms:
Could It Be A Bad Fuse?
The engine light indicator blinks or remains steady on dash when engine computer noticed any problem with any engine electrically operated components. Crawl under the truck on the drivers side and you will see the nsbu switch. Slide under the car and check for a loose gear shift cable.
