Forced Air Kerosene Heater Troubleshooting. Kerosene forced air heater user’s manual ® fueling the heater: Start heater by pushing toggle switch to “on” position (light signifies switch is in “on” position.) 4.
Protemp 75,000BTU Forced Air Kerosene Heater at from www.lowes.com
If the problem persists, replace the oil flame control assembly. Keep this manual for future reference. Kerosene heater gives off a strong odor
• When Used With Thermostat, Heater May Start Anytime.
Raise the wick as high as. Light the wick with your match and adjust the size of the flame to the recommended settings for your unit. First, open the body of the heater and use the burner knob to raise the burn chamber and wick.
As Always, You Can Contact Us Or.
It uses air (oxygen) from the area in which it is used. Heater ignites, but ignition control shut heater off after a short period of time refers to pg#16 check connections how do i get heater to work ? Plug the heater into a grounded 115v, 60 hz, 1 ΓΈ outlet.
Carefully Place The Screwdriver On The Internal Fan And Gently Press.
2 3 table of contents safety 6 safety rules 7 safety warnings 9 safety precautions 10 operating precautions specifications 11 specifications 12 features 12 dimensions. Never leave heater unattended while burning or while connected to a power source. Remove the protective grill from the heater's front opening with a screwdriver.
Sparks, Calling For Flame, But 1) Check Wiring To Motor (Per Wiring Schematic In Manual).
Trouble shooting symptom cause cause problem step 1 step 2 did not wait 2 hours after replacing wick wick does not burn well, smells replace wick use of wrong kerosene measure the specific gravity of kerosene kerosene container or fuel. Allow it to burn dry until the flame starts to go out. Start heater by pushing toggle switch to “on” position (light signifies switch is in “on” position.) 4.
Series Kerosene/Diesel Portable Forced Air Heaters Owner’s Manual Table Of Contents
Light the kerosene heater with little kerosene in the fuel tank. Disconnect the power plug and pull the top of the heater off and check that all of the rubber air and fuel lines are connected. If damaged, replace rotor assembly.
